Vehicle Search | Manage My Vehicles         Part Search | Manage My Parts        

    Whitey Ford

    Not For Sale

    4 Comment(s)

    Matthew K

    • Year:1995
    • Make:Ford
    • Model:Bronco

    Engine : 5.8, K&N FIPK, 3" Magna-Flow exhaust and performance cats, Flex-a-lite dual electric fans, 200 amp alternator, Optima yellow-top battery.

    Drivetrain : 4.11s front and rear, Yukon Axles in rear, rear Ox Locker with cable shift.

    Transmission : no info

    VIN : no info

    4" Rancho lift, 35" Coopers, TJM front bumper, Cross Ent. rear bumper with tire carrier and jerry can rack, Mile Marker winch, cross drilled front rotors, Tuffy center console and rear storage drawer, Hercu-Liner floor with diamond plate interior side panels, Smitty-Built roll bar, STC soft top, Hella driving lights and Vision-X LED backup light.

    Comments (4)

    You must login to post a comment.

    Reviewed by: Donald E 02/20/13 12:24AM

    Comments:
    sweet bronco. see it all the time here in santa fe nm. im getting my white 96 bronco lifted 6'' soon. lets hit the trails

    Reviewed by: John A 10/19/13 12:08PM

    Comments:
    Its nice to see a fellow Bronco owner have pride in building a good off-roader and not afraid to actually go on off-road and see something new....

    Reviewed by: Joey B 11/07/13 10:26PM

    Comments:
    How did you get 35's to fit with only a 4in lift?? I have a 93, ideally I wanna go with a 4" lift and 35's but I don't want to cut fenders?? Is this possible??

    Reviewed by: Matthew K 11/08/13 07:43AM

    Comments:
    Joey, if you look closely at the pictures maybe you can see that the bottom rear corners of my front fenders have been trimmed and folded in just a little bit. That and getting the right back-spacing (four and a half inches, I think) on the ten inch wide rims was all it took to get the 35s to fit without rubbing.