300 L6 .030. 252 Comp Cam. Metal timing gears. Clifford single plane intake. 500 CFM Edelbrock AVS Carburetor (Manual Choke). Magnaflow (1996 fuelie exhaust) header and cat. Motor has less 30k on full teardown, and 0 miles on top end (blew a head gasket between IIRC #2 and #3; I definitely remember it was just a compression loss, only drove it for 8 miles), buffed out nicks burrs and cuts out of head (not port and polish by any means). Re ground and seated valves. Fresh springs, clips. Cam has 0 miles (Originally put Comp 268 in it, but truck originally was a manual). Fel Pro gaskets (1 piece/1996 Oil Pan gasket).
Wonder about the title? Yes, I tried it. When the speedo is registered 85, and the needle is at 5:30 to 6:00 position, you figure it out (keep in mind, past 55, what the needle says is actually a bit under what you are actually going!).